Staff by Department
Search GPLS

Strategic Plan for Georgia Public Library Service


Georgians can now
register to vote online!

Register to Vote Georgia

Add this link to your library website!

DigiKit: Unboxing and Setup

Unboxing the DigiKit Equipment

  1. Enter the code to open the combination lock.  You should have received the lock code upon confirmation of equipment receipt with HomePLACE. If you have not received the lock code, contact the HomePLACE Director.
  2. Unlock the Pelican case. There are six latches securing the lid: two latches on each of three sides. Pull the latch up until it releases with a ‘pop.’
  3. Lift the lid open and remove the top layer of protective black foam.
  4. You will need two people to remove the scanner from the Pelican case.  Gently reach your fingers down between the protective black foam and the narrow end of the scanner.  The second person should repeat on their end. Carefully lift the scanner up and out of the Pelican case and gently rest it on your work surface.
  5. ! Caution: At 29lbs, the scanner is unexpectedly heavy. Use care when removing the scanner from the Pelican case. Lift straps are provided for your convenience.
  6. Reach inside the Pelican case and remove the bottom layer of black protective foam (on which the scanner was sitting) to reveal the HP laptop. Carefully remove the laptop from the case and gently rest it on your work surface.
  7. Remove the laptop power adapter.
  8. Remove the scanner power adapter, connecting cable, and
  9. Remove the external hard drive, power adapter, and connecting cable.

Setting Up Your DigiKit Station

NOTE: The Epson scanning software is already installed on the laptop, so you may skip the first part of Step 2 in the diagram below.

HomePLACE is supported with Federal LSTA funds administered by the Institute of Museum and Library Services through the Georgia Public Library Service, a unit of the Board of Regents of the University System of Georgia.


Georgia Public Library Service

Promote Your Page Too